VDP150OAW8
1
VELLEMAN
VDP150OAW8 – BEAM TRACKER 150
1. Introduction & Features
Thank you for buying the
VDP150OAW8
! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
The
VDP150OAW8
comes with a power cable, an XLR connection cable and this manual. It features:
•
High speed pan (540°) and tilt (280°) movements
•
11 dichroic c white
•
colour wheel with rainbow effect in both directions
•
strobe: 0~8Hz, pulse strobe or sound activity strobe
•
music control or DMX control selectable
•
display for digital address and function setting
•
display can be turned 180° if required by the mounting location
•
DMX mode, stand-alone mode or master-slave synchronic mode
•
Memory function: automatic pan/tilt position correction
•
On-board programming, 3 programs of 99 steps each
•
4 protocol modes thru DMX programming
•
soft edge output from 80mm PC lens, 20° beam aperture
•
pre-programmed macros with variable and random pulse effect
•
Dimmer unit allowing very smooth micro-step driven dimming
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
•
A qualified technician should install and service this device.
•
Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
•
This device falls under protection class I. It is therefore essential that the device be earthed. Have a qualified
person carry out the electric connection.
•
Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
•
Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
•
Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
•
There may be some smoke or a particular smell when the device is activated for the first time. This is normal and
any smoke or smell will gradually disappear.
•
Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
•
Note that damage caused by user modifications to the device is not covered by the warranty.
•
Keep the device away from children and unauthorised users.
