Operational
Operational using the Remote Control.
Custom default start up setting:
It is possible to change the default start up setting. E.g. if the optical
input is often used, it can be a nice feature to have the DAC unit start
up with the Optical input as default.
By pushing the
DSP
button in the "setting state” the unit will save the
status for next switch-on.
Phase invert, Digital filter selections, volume level and input selection.
Selecting input:
Push
CH+
or
CH-
buttons on the Remote Control to select the wanted
input.
When the input is selected and locked, the front panel displays input
type, which can be either PCM or DSD. For PCM input the sampling
frequency shows and for DSD input the sampling rate shows.
Volume Level:
The volume can be adjusted by using the Remote Control buttons
V+
or
V-
. The front panel displays the volume level.
MUTE:
To mute the analog output, push the
Mute
button. Push the
Mute
again for unmute the analog output. The Front panel will display the
Mute status.
Digital filter selection:
The unit offers a wide choice of filters to enhance your listening
experience. Two digital filter settings are possible, sharp roll-off and a
slow roll-off for PCM mode. For DSD mode, there are 4 available filters
with cut off at 47kHz, 50kHz, 60kHz and 70kHz.
For filter selection use the Remote Control.
Enter the programming mode by Pushing the
SET
button.
PCM filters: Select sharp roll-off or slow roll-off by pushing the buttons
V+
or
V-
DSD filters: Select cut off at 47kHz, 50kHz, 60kHz or 70kHz by pushing
the buttons
CH+
or
CH-
Select the desired filter setting and Save the new setting by pushing the
DSP
button followed by the
SET
button
DISPLAY Light:
Push the
PWR
button on the
Remote Control for switching
On and Off the display backlight.
Phase invert:
Note: Phase invert is only possible
when using following inputs:
AES, COAX, OPTICAL.
Change phase by pushing
SET
for
stepping in to the setting state, push
the
MUTE
button for Phase invert.
For saving the new setting: push the
DSP
button followed by
SET.
SET PWR
V- CH-
V+ CH+
MUTE
DSP
