HPEVS Curtis 1239 E, Электрические схемы и документация

Страница: 10 / 57

10
Pin # Name Function Terminations Wire color Detailed Description
1 KSI Keyswitch_Input Blue
Keyswitch input. Provides logic power for the controller and power
for the coil drivers.
2 Prop. Driver Tachometer Driver Orange/Blk Digital output used to drive a tachometer
3 Driver 4 Brake Light Relay Orange Brake light relay driver
4 N/C Precharge Grey Precharge relay driver
5 Switch 10 Clutch/Shift Switch Wht/Blue Switch input is used to reduce neutral braking while shifting
6
Driver 1 Main_Contactor Orange/Wht
Main Contactor Coil Driver.
7 I/O Ground Black/Blue Input and output ground reference.
8 Analog 2 Motor_Temperature_Sensor Yellow/Black Used as the motor temperature analog input
9 Switch 3 Accel_Switch_Input
Active high, connect to 12
volts. See schematic
Green
Used as safety interlock; switch is open when throttle switch is
released. Type 2 & 3 throttle only.
10
Menu Menu_Button
Active high, connect to 12
volts. See schematic White/Red
Momentary switch; used to scroll through 840 spyglass display
11 Switch 5 Start_Switch_Input
Active high, connect to 12
volts. See schematic Purple
Momentary switch; Enables drive system when Idle function is turned
ON.
12 Switch 6 Economy_Mode_Switch_Input Brown Switch input used to activate Economy Mode.
13 Coil Return Coil Return Common to all relay coils
Blue/White
This is the coil return pin (at B+ potential) for all the contactor and
relay coils.
14 Brake Switch Input Brake_Sw White/Black Switch input used for brake rate.
15
Throttle Pot High Pot High Black/Wht
Pot high connection for a 3-wire throttle pot.
16
Throttle Pot Wiper Pot Wiper Yellow/Wht
Wiper or throttle input.
17 Pot2 Wiper Brake Pot Wiper Yellow/Red Brake input.
18 Pot Low Pot Low Purple/Wht Pot low connection for brake and throttle.
19 N/C
20 N/C
21 CAN Term H CAN Termination Black CAN termination jumper.
22
Switch 7 Forward_Switch_Input
Active high, connect to KSI
to activate. White
Used by the Motor Control to select forward direction
23 CANH CAN High Orange CAN bus high.
24 N/C
25 +12V Out Red/Blue Unregulated low power +12V output.
26 +5V Out Red/White Regulated low power +5V output.
27 N/C
28 Serial TX White Serial transmit line for display or flash update.
29
Serial RX Green
Serial receive line for display or flash update.
30 N/C
31 Encoder Phase A MotorspeedA_Input Tan/Black Quadrature encoder input phase A
32 Encoder Phase B MotorspeedB_Input Tan Quadrature encoder input phase B
33
Switch 8 Reverse_Switch_Input
Active high, connect to KSI
to activate.
Yellow Used by the Motor Control to select reverse direction
34 CAN Term L CAN Termination Black CAN bus termination jumper.
35 CANL CAN Low Grey CAN bus low.
Generic Software 538 Switch Pin Out Specific for 1239 Controller Single Motor or Primary in Dual Motor Applications