Page 12
881627-002 Edition 3
3. Installation
3.1 Unpacking and contents verification
(1)
HPE 1U UPS
(2)
Documentation
(3)
RS-232 communication cable
(4)
USB communication cable
(5)
1U Rack kit
(6)
Bezel parts
(7)
Two connection cables for the protected equipment (for International models only)
(8)
Cable locking system
Packing materials must be disposed of in compliance with all local regulations concerning waste.
Recycling symbols are printed on the packing materials to facilitate sorting.
2
6
1
3
4
5
7
8
3.2 Battery module connection
CAUTION:
This operation must be performed when the UPS is switched off and unplugged from the AC
source.
Do not disconnect the connector while the unit is operating from the AC source or in reserve mode.
NOTE:
Before starting the UPS, you must connect the internal battery. A small amount of arcing may occur
when connecting the batteries. This is normal and does not damage the UPS or present any safety concern.
A
Connect the battery module.
Never pull on the wires.
B
Slide the left-hand side of the
bezel to the right. Ensure that the
pushbutton locks.
C
Attach the center panel.
