344
<PE1> display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 2, 1 up, 1 blocked, 0 down, 0 defect
Xconnect-group Name: vpna
Peer PW ID In/Out Label Proto Flag Link ID State
2.2.2.2 20 65651/65779 LDP M 1 Blocked
3.3.3.3 30 65650/65779 LDP B 1 Up
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)
Configuring an intra-domain multi-segment PW
Network requirements
As shown in
, there is no public tunnel between PE 1 and PE 2. There is an MPLS TE
tunnel between PE 1 and P, and an MPLS TE tunnel between P and PE 2.
Configure a multi-segment PW between PE 1 and PE 2, so CE 1 and CE 2 can communicate over
the backbone. The multi-segment PW includes an LDP PW between PE 1 and P, and a static PW
between P and PE 2. The two PWs are concatenated on P.
Figure 92 Network diagram
Table 34 Interface and IP address assignment
Device
Interface
IP address
Device
Interface
IP address
CE 1
Vlan-int10
100.1.1.1/24
P
Loop0
192.4.4.4/32
PE 1
Loop0
192.2.2.2/32
Vlan-int23
23.1.1.2/24
Vlan-int23
23.1.1.1/24
Vlan-int26
26.2.2.2/24
CE 2
Vlan-int10
100.1.1.2/24
PE 2
Loop0
192.3.3.3/32
Vlan-int26
26.2.2.1/24
Configuration procedure
1.
Configure CE 1.
<CE1> system-view
[CE1] vlan 10
[CE1-vlan10] quit
[CE1] interface vlan-interface 10
MPLS backbone
CE 1
CE 2
PE 1
PE 2
P
Vlan-int23
Vlan-int23
Vlan-int26
Vlan-int26
GE1/0/1
GE1/0/1
GE1/0/1
Vlan-int10
GE1/0/1
Vlan-int10
Loop0
Loop0
Loop0
Tunnel1
Tunnel2
Site 1
Site 2
Содержание FlexNetwork 5510 HI Series
Страница 9: ...vii Remote support 460 Documentation feedback 460 Index 462 ...
Страница 318: ...309 Request list 0 Retransmit list 0 ...
Страница 363: ...354 Verify that CE 1 and CE 2 can ping each other Details not shown ...
Страница 446: ...437 The MCE has redistributed the OSPF routes of the two VPN instances into the EBGP routing tables of PE 1 ...