HPA-Faip M 830 LL, Руководство оператора

Страница: 60 / 87

146 M 830 LL - M 830 M User Manual
7. From the position of the centring ridges check that the beads are properly positioned
on the rim; otherwise, deflate the tyre, break the beads as described in the relevant sec-
tion, lubricate and turn the tyre on the rim. Repeat the mounting operation described
previously and check again.
8. Replace the internal mechanism of the valve.
9. Bring the pressure to the operating value by pressing the Inflation push-button (5,
Fig. 43c).
10.
Fit the cap to the valve.
6.11.c. SPECIAL PROCEDURE (FS VERSION)
Before carrying out operations descibed below, always make sure that there is no
dirt, dust or other impurities on the jaws near the air outlet holes.
If, during inflation, the tyre does not seat on the rim because of the excessive gap be-
tween the tyre/rim, it is possible to use an air-pressure airblast through the jaws on the
FS accessory.
Verify that both upper and lower tyre beads and the rim bead seat have been properly
lubricated with an approved mounting paste.
1. Make sure the wheel on which the tyre is fitted is securely clamped on the turntable
by the centring handle (Fig. 44a).
2. Make sure the tool head and the bead breaking unit are not near the work area, and
if possible are in the rest position .
3. Remove the valve stem core if not already done (Fig. 44b).
WARNING
44a 44b
4. Connect the air hose Doyfe inflator chuck to the valve stem (2, Fig. 44c).