HP Z Workstation series, Руководство пользователя

Страница: 71 / 76

Installing an ODD in an HP Z600 or Z800 Workstation
To install an ODD:
1. Follow the procedures described in Preparing for component installation on page 43 to prepare
the workstation for component installation.
2. If necessary, lift the optical bay filler tray handle and remove it from the workstation.
3. Lift and hold the green optical drive bay release latch (1) while sliding the drive into the bay (2).
When the front of the optical drive is near its final position, let go of the latch, but continue to
slide the drive inward until the latch closes and engages the drive as shown below. (An HP Z600
Workstation is shown for example.)
TIP: During installation the adjacent drive or filler may move slightly. It may be necessary to
slide and align both devices to get the release latch to close and engage both devices.
CAUTION: Verify that the optical drive is secure in the workstation chassis by pulling on the
drive to see if it can be easily disengaged. Failure to properly secure the drive can damage the
drive when moving the workstation.
Figure 10-4 Installing the optical drive
ENWW Installing an ODD in an HP Z600 or Z800 Workstation 63