HP VXI Pentium Series, Руководство по установке и настройке оборудования

Страница: 48 / 80

Troubleshooting 45 Chapter 4
Chapter 4
Troubleshooting
About this Chapter
This chapter helps you resolve error messages or other common problems
you may encounter while installing the VXI Pentium Controller hardware.
This chapter contains the following troubleshooting sections:
•
Abnormal LED Indicator States
•
BIOS Error Messages
•
Problems After Configuring the BIOS
Note
For information on:
•
The meaning of the LED indicators on the front panel of the controller,
please see Appendix A.
•
Using the BIOS Setup utility, please see Chapter 3.
Abnormal LED Indicator States
The state of the LEDs may indicate the following abnormal conditions.
Cycle the power to the controller to see if this problem rectifies itself. If the
LED indicators are still in an abnormal state, please contact your HP Service
and Support Center for assistance. See Appendix F, “POST Beep Codes”,
for additional information that may be useful to service personnel.
Table 4-1. Abnormal LED Indicator States
LED Abnormal
State
Abnormal Condition
RUN Not Lit The CPU has halted. Blinking during operation is normal.
TEST Stays Lit The controller did not pass its power-on self-test (POST).
This LED will normally be lit during the POST phase of
the boot. Once POST is complete, it should go out.
SCSI Stays Lit SCSI port operation failed.
IDE Stays Lit IDE disk error.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com