HP Vectra VT 6/xxx, Руководство пользователя

Страница: 107 / 168

English 95
4 Troubleshooting Your PC and Using the Setup Program
If Your PC Has a Software Problem
If You Can’t Start the Setup Program
This may happen if the copy of the PC’s configuration stored in
memory is corrupted. You will need to erase this bad configuration.
To clear the configuration:
1 Switch off the PC and remove the cover (refer to chapter 3).
2 Set the system board switch 1 (CONFG) on the switch block to ON
to clear the configuration (refer to page 122 for the switch location).
3 Switch on the PC to erase the memory.
4 Check that error codes
0240
and
0130
are displayed, and wait until
the PC has started.
5 Switch off the PC.
6 Set the system board switch 1 (CONFG) on the switch block to OFF
to re-enable the configuration.
7 Replace the cover (refer to chapter 3).
8 Switch on the PC and run Setup by pressing when
<Setup=F2>
appears. (Error code
0130
will appear when the PC
starts.)
9 Press to save the configuration and exit from Setup.
If the Date and Time Are Incorrect
The date and time can be incorrect for the following reasons:
•
the time has changed for the seasons
•
the PC has been unplugged from the power too long, and the Gold
Capacitor which supplies power to the CMOS memory has
discharged.
Use the Setup program to change the date and time.
margeaux.bk : marg-ue4.fb4 Page 95 Monday, July 21, 1997 4:28 PM