HP Vectra VL6 6, Руководство по установке

Страница: 27 / 40

4 Connecting to a Windows NT Server 4.0
Windows 95 SR2
Windows 95 SR2 Requirements
• HP Vectra with Windows 95 SR2.
• 3COM Etherlink 3C900 Ethernet card and drivers disk Ver. 2.1.
Driver Name: El90X.DOS Size: 45KB Date: 3/21/97
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Network Driver Optimization Normal
• Full Duplex Auto Select (N-WAY)
• Boot PROM Disabled
• Media Type Auto Select (N-WAY)
• I/O Base Address FCC0h (PCI)
• Interrupt Request Level 9 (PCI)
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink 3C900 adapter
card into an PCI slot.
2 Connect network Cable media to the 3COM 3C900 card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM drivers disk 1 “Etherlink 3C900 Ethernet
Drivers Ver. 2.1.” and execute “A:\3C90XCFG.EXE.”
5 Select “Configure NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
6 If changes are required, save those changes and exit.
7 Remove the 3Com Software driver diskette and reboot the machine.
8 When Windows 95 restarts a message will appear that new hardware has
been found.
9 Insert 3Com Etherlink 3C900 software disk 1 of 2 ver 2.1.
10 Click “Next” to begin hardware wizard on the “Update Device Driver
Wizard” dialog message.