44
3 Troubleshooting and Repair
Using SETUP to Configure the PC
Memory and Cache
Memory caching
Both
Controls internal (L1) and external cache (L2) memory
caching.
Memory hole
Disabled
Sets a 1MB memory hole between 15 and 16MB if
needed. You need at least 16 MB for this option to be
available.
Shadow/Cache ISA Option
ROMs
Enabled
Enables shadowing and caching for ISA “Non-PnP” Option
ROMs for region X-Y, in order to improve performance.
Note that some Option ROMs cannot be shadowed.
Hard Disk Drives
Hard disk drive 0 (xxxx MB)
540 MB
Configure IDE drive 0. It is not recommended to connect a
CD-ROM on a channel which already has an IDE hard disk
drive. Sub-menu items for each of these fields are given
below “On-board Bus IDE adapters” in this table.
Hard disk drive 1 (xxxx MB)
xxx MB
Hard disk drive 2 (xxxx MB)
xxx MB
Hard disk drive 3 (xxxx MB)
xxx MB
Translation method
Extended
Select “Standard” only if you are running a UNIX
Operating System.
On-board Bus IDE adapters
Both
Enable or disable the on-board IDE adapters.
“Primary” enables only the HDD data cable (marked
“HDD” next to the system board attachment).
“Both” enables the HDD data cable and the CD-ROM data
cable (marked “CD-ROM” next to the system board
attachment).
Autotype fixed disk
Automatically attempts to detect and identify the IDE
drive when you press the Enter key.
Type
User 540 MB
Select “Auto” for automatic hard disk drive detection. (To
initiate automatic hard disk detection, press the Enter key
at the “Autotype fixed disk” item). “User” allows you to
edit all the detected parameters. Select “CD” if drive is an
IDE CD-ROM, and “None” if there is no drive.
Cylinders
944
Sets the number of hard disk drive cylinders.
Heads
14
Sets the number of hard disk drive heads.
Sectors/Track
40
Sets the number of hard disk drive sectors per track.
Multi-sector transfers
8 sectors
Determines the number of sectors per block for multiple
sector transfers.
LBA mode control
Enabled
Enable or disable Logical Block Addressing mode in place
of Cylinder Heads Sectors.
32 bit I/O
Enabled
Enable or disable 32 bit data transfer.
Transfer mode
PI0 mode 3
Selects the hard disk drive transfer mode and data
transfer rate.
Setup Item
Default
Action
Содержание Vectra VL 5/xx MT series
Страница 2: ...Contents iv ...
Страница 38: ...40 2 PC Hardware Structure Installing Accessories ...
Страница 50: ...52 3 Troubleshooting and Repair HP Vectra Diagnostic Utility ...