HP T2touch PANEL, Руководство по обслуживанию

Страница: 10 / 66

HP T2touch PANEL CUSTOMER
SUPPORT
SERVICE MANUAL
Step 5
(Knob
Position
5)
Motor CW (Tumble CCW) -Motor
stops 10
sec
- -
Service must check
whether tumble is
moving to CCW
*If tumble is moving to
CW again, then motor
relay short circuit CCW
Step 6
(Knob
Position
6)
Check Heater NTC if heater NTC
T=255
5 sec E05 -
*Heater NTC connector
is taken out or short
circuit
Step 7
(Knob
Position
7)
Check Door NTC if heater NTC
T=255
5 sec E06 -
*Door NTC connector is
taken out or short circuit
Step 8
(Knob
Position
8)
Compressor OFF- Motor CCW
(Tumble CW) OFF- Cooling fan
ON
10
sec
- -
Service must check
power of at the home
voltage and fan will be
controlled manually by
technical service.
Step 9
(Knob
Position
9)
Compressor ON- Motor CCW
(Tumble CW) -motor off 10
sec
- -
Service must check
power of at the home
voltage.
Step 9
(Knob
Position
9)
Check conductivity sensor when
door is opened and motor is off
5 sec
E01 -
Service puts his hand on
the humidity sensor
plates and software
checks sensor data
*If sensor data=0,
humidity sensor
connector is taken out
Remove
the last
error
(Knob
Position
1)
5 sec DEL
DL is visualized
on display and
make fast blink
for 2 sec for
T0.DEL is
visualized on
display and
make fast blink
for 2 sec
When the knop
positioned to program 1,
service will pust the
both SW4 and SW5 for
T0/T1 (child lock mode).
When the knop
positioned to program 1,
service will pust the
both SW2 and SW3 for
T2 (child lock mode).