HP R100-Series, Руководство по настройке и администрированию

Страница: 78 / 142

78 VPN configuration
•
Enable Auto Reconnect : For L2TP client connections, you can automatically reconnect
when there is activity after a disconnection.
•
Remote Server : Enter the remote server IP address.
IPSec Setting
•
Pre-shared Key : When set to client mode, enter the key for the client connection. Do not
use these characters: ` " & ' # \
•
Remote Party ID : When set to server mode, select either ID_IPV4_ADDR or
ID_USER_FQDN .
If ID_IPV4_ADDR is selected, enter the IPv4 address in the box next to the list.
If ID_USER_FQDN (fully qualified domain name) is selected, enter the name in the box
next to the list. For example, a user FQDN could be a mail address, such as
my_name@mycompany.com .
Remote Networking Setting
Enable the remote network setting, and then set the IP address and subnet mask.
PPTP settings
The Point-to-Point Tunneling Protocol is used by some ISPs in Europe. This router allows
computers to use the Internet to remotely log into the LAN using the PPTP tunneling protocol.
You can configure the detailed PPTP tunnel settings on the VPN connection page by clicking
Add . You can specify the Idle Timeout, which defines the time period without traffic after which
the PPTP session is terminated. You can also configure the router to behave as either a client or
server. For a client tunnel, both the host mode and network mode (LAN-to-LAN) are supported.
The tunnel can also be configured to automatically reconnect to the server when Internet traffic
is generated.
The VPN connection page displays when you click
Add
on the VPN Settings page. From the
VPN connection page you can configure detailed parameters for your PPTP VPN connection. A
maximum of five PPTP connections can be defined.