HP ProLiant StorageWorks NAS 1500s, Руководство по установке

Страница: 28 / 54

28 NAS 1500s Installation Guide
Procedure
To initialize the NAS 1500s:
Caution: Do not power up the NAS device until steps 1
through 5 are completed.
1. Connect the Ethernet cables to the respective network ports
of the NAS 1500s and the corresponding network segments.
See
Figure 2 and Table 2 for the locations of the network
ports on the NAS 1500s.
Note: Connect a loopback cable to any of the NAS 1500s Ethernet
ports that are not configured for use.
2. Verify that the Windows-based PC client is connected to the
same subnet as the NAS 1500s.
3. Power on the PC and wait until the operating system has
completely loaded.
4. Insert the RapidLaunch CD into the CD-ROM drive of the
PC.
5. The RapidLaunch CD should run automatically. If the
program does not start up automatically, the program may be
run manually. Click Start, select Run on the Windows
taskbar, and then type the following:
{CD ROM drive}:\setup.exe
Wait for the interface to start.
6. Go to the NAS device and power it on. It will be several
minutes before the NAS device is accessible on the network.
7. Return to the PC. Select StorageWorks NAS from the Show
drop-down list to have RapidLaunch list all NAS devices on
the network, as shown in
Figure 5 .