HP Power Supplies
Select one or more power supplies from Core Options-Power Supplies section below:
Prior to selecting a power supply option, it is highly recommended that you review your server
configuration in the HP Power Advisor tool to determine the right size power supply for your server
configuration. The HP Power Advisor is located at:
www.hp.com/go/hppoweradvisor
.
Mixing of power supplies in the same server is not supported. All power supplies must be of the
same input voltage, output rating, and efficiency rating. If non-matching power supplies are
installed, you may receive an error message and/or experience operational issues with your server.
Step 3: Choose Additional Factory Integratable Options
HP Networking
Select a standup NIC adapter from Core options-Networking section below,
Please see the QuickSpecs for Technical Specifications and additional information:
www.hp.com/go/ProLiantNICs
These options are upgradeable and can be changed from the original configuration after the server
is shipped.
For 10Gb adapters, a minimum of two Gigabytes (2 GB) of server memory is required per each
adapter.
HP Drives
Select one or more drives from Core options-HP Drives section below:
The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the
server backplane) should operate at the same data transfer rate or the system bandwidth will be
negotiated down to an acceptable level for all components.
Hard drives have either a one year or three year warranty; refer to the specific hard drive QuickSpecs
for details.
The HP ProLiant Gen9 Smart Storage solutions are equipped with re-designed Small Form Factor
(SFF 2.5 in) and Large Form Factor (LFF 3.5 in) hot plug carriers for HP Qualified Hard Drives and
Solid State Drives. These new carriers provide status and activity indicators as well as caution
indicators for "Do Not Remove".
HP Graphics Options
Select one or more graphics adapter from Additional options section below.
Please see the HP Power Advisor for estimated power consumption of your individual system
configuration prior to installing GPUs. The HP Power Advisor is located at:
www.hp.com/go/hppoweradvisor
This section may contain FIO options, please see HP Computation & Graphics Accelerators section
below.
HP Unique Options
Select one or more Unique options from Core options section below.
This section may contain FIO options, please see the Unique options section below.
FIO indicates that this option is only available as a factory installable option.
HP Cooling Options
Select one or more Fan Kits from Core options section below.
This section may contain FIO options, please see HP Cooling Options section below.
FIO indicates that this option is only available as a factory installable option.
HP Storage Controllers
Select one or more Storage options from Additional options section below.
The embedded B140i controller will operate in UEFI only mode. For legacy support an additional
controller will be needed, and for CTO orders please also select the Legacy mode settings part,
758959-B22
This section may contain FIO options, please see HP Storage Controllers section below.
FIO indicates that this option is only available as a factory installable option.
HP Rail Kits
Select one type of rail kit from Additional options section below.
Please take a moment to review the installation documentation that comes with the server to help
you with the installation of your Gen9 server.
To assist in the installation of the server into the rack, an optional installation tool is available by
contacting your local services representative (p/n 695539-001).
QuickSpecs
HP ProLiant ML350 Generation9 (Gen9)
Configuration Information - Factory Integrated Models
DA - 15035 Worldwide QuickSpecs — Version 2 — 9.23.2014
Page 17