HP ProLiant DL60 Gen9, Руководство по техническому обслуживанию и ремонту

Страница: 49 / 113

Removal and replacement procedures 49
4.
Remove the access panel (" Access panel " on page 37 ).
5.
Remove the air baffle (on page 31 ).
6.
Disconnect the fan cable from the system board and remove the fan.
CAUTION: The fan does not have a fan guard. Special attention is needed when removing or
installing the fan to prevent finger injury.
To replace the component, reverse the removal procedure.
DIMMs
Memory-processor compatibility information
•
Intel Xeon E5-2600 v3 processors are optimized for:
o
Single-rank and dual-rank PC4-2133 (DDR4-2133) RDIMMs operating at up to 2133 MT/s
o
Dual-rank and quad-rank PC4-2133 (DDR4-2133) LRDIMMs operating at up to 2133 MT/s
•
Intel Xeon E5-2600 v4 processors are optimized for:
o
Single-rank and dual-rank PC4-2400T (DDR4-2400) RDIMMs operating at up to 2400 MT/s
o
Dual-rank PC4-2400T (DDR4-2400) LRDIMMs operating at up to 2400 MT/s
For the latest memory configuration information, see the product QuickSpecs on the Hewlett Packard
Enterprise website ( http://www.hpe.com/info/qs ).
Removing a DIMM
To remove the component:
1.
Power down the server (on page 27 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page 27 ).