NOTE:
This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on
configurable product offerings and requirements.
NOTE:
Factory Integrated Models must start with a CTO Server.
NOTE:
FIO indicates that this option is only available as a factory installable option.
NOTE:
All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
Step 1: Base Configuration (choose one of the following configurable models)
NOTE:
Rail kits and cable management solutions are optional in CTO. See "Step 3: Choose Additional Factory Integratable Options" for
details on ordering.
NOTE:
The DL360e ships standard with the HP Dynamic Smart Array B120i Controller which provides support for up to 6 SATA drives
(greater than 4 drives requires additional cable, PN 675856-B21) and data transmission speeds up to 3Gb/s. Customers requiring SAS
support or greater than 6 drives should select either a Smart Array family controller or the SAS Riser FIO kit (PN 661387-B21) that
includes HP Dynamic Smart Array B320i Controller Up to 8 SAS drives can be supported with HP Dynamic Smart Array B320i controller.
NOTE:
When the SAS-enabled riser board with the Smart Array B320i controller is installed in the server, the embedded Smart Array
B120i controller is automatically disabled. In the absence of another storage controller or an expander backplane, drives operate in
ACHI or Legacy mode. In these two modes, the drives are not part of a hardware RAID or a member of a logical drive. The Locate, Drive
status, and Do not remove LEDs in the drive carrier are disabled.
NOTE:
Power Supply not included - choose from Power Options section.
NOTE:
HP Smart Array P222 Controller and HP H222 Host Bus Adapter can be selected with only 4LFF models.
NOTE:
HP Smart Array P822 Controller and HP H220 Host Bus Adapter can be selected with only 8SFF models
HP Models
HP ProLiant DL360e Gen8 8 SFF Configure-to-order Server
661189-B21
Factory Integrated Model ships with:
2 x HP Smart Socket Guides for fast processor installation
Drive Cage - 8-Small Form Factor
12 DIMM slots for RDIMM, LRDIMM and UDIMM SmartMemory installation
HP Ethernet 1Gb 4-port 366i Adapter
HP Dynamic Smart Array B120i Controller (Cache connection for 512MB FBWC options)
I/O slots - 2 Slots come standard:
Slot 1 - Full-Height/Half-Length (250mm) x 16 PCIe 3.0
Slot 2 - Low Profile x 8 PCIe 2.0
System Fans - 4 (4 additional fans included with second processor kit)
USB - 4 Rear, 2 Front, 1 Internal
1 Internal SD slot
HP iLO Management Engine (standard)
NOTE:
New options are available for Rack Rail Kits; these options are no longer
standard on-board with this Model Part Number. Please see HP Rack Options below for
optional required options.
HP ProLiant DL360e Gen8 4 LFF Configure-to-order Server
661190-B21
Factory Integrated Model ships with:
2 x HP Smart Socket Guides for fast processor installation
Drive Cage - 4-Large Form Factor
12 DIMM slots for RDIMM, LRDIMM and UDIMM SmartMemory installation
HP Ethernet 1Gb 4-port 366i Adapter
HP Dynamic Smart Array B120i Controller (Cache connection for 512MB FBWC options)
QuickSpecs
HP ProLiant DL360e Generation 8 (Gen8)
Configuration Information - Factory Integrated Models
DA - 14327 Worldwide — Version 33 — December 16, 2013
Page 21
