3
PCI-Express
2.0
x8
x8
6
Low Profile
3.3 volts
Half-height PCIe Riser
(Standard with half-height
1U nodes)
Expansion
Slots #
Technology
Bus
Width
**
Connector
Width
*
Bus
Number
Form
Factor
Notes
1
PCI-Express
2.0
x16
x16
4
Low Profile
3.3 volts
* Default bus assignment. Inserting cards with PCI bridges may alter the actual bus assignment number.
** Indicates the number of physical electrical lanes running to the connector.
Storage Controller
Non-Hot Plug SATA Models Embedded HP Smart Array Hot Plug Advanced Pack for B110i (RAID 0, 1, 10)
NOTE:
Transfer rate: up to 3 Gb/s SATA
NOTE:
To enable RAID on Embedded SATA (Windows and Linux only), use the
HP Smart Array B110i SATA Raid controller, To enable use of the B110i, enter
the ROM based setup utility(RBSU). The option for enabling RAID can be found
in the advanced section of the RBSU. For additional details
www.hp.com/go/SATARAID
. For RAID on Solaris, a Smart Array Controller
must be purchased.
Hot Plug SATA Models
Embedded HP Smart Array Hot Plug Advanced Pack for B110i (RAID 0, 1, 10)
NOTE:
Transfer rate: up to 3Gb/s SATA
NOTE:
The HP Smart Array B110i SATA Raid Hot Plug Advance Pack provides
the hot-plug and RAID support for the embedded SATA controller. The Hot
Plug Advance kit is a License to enable the RAID support on Hot Plug models. It
supports up to six 3G SATA hard disk drives. It will support a maximum of two
(2) logical drives. It supports Raid 0, 1 and 1+0. For additional details
www.hp.com/go/SATARAID
Hot Plug SAS/SATA Models HP Smart Array Controller RAID 0,1,10, 5
NOTE:
Transfer rate: up to 6GB/s SAS, 3Gb/s SATA
NOTE:
SAS Upgrade: A HP Smart Array Controller is required for SAS HDD support. Transfer rate: 6.0 Gb/s
SAS supported.
NOTE:
If a Smart Array P410 Controller is added after initial purchase (e.g. an upgrade) a HP DL170e G6
P410 CONTROLLER CABLE OPTION KIT (P/N 612206-B21) must be ordered to connect the Smart Array
Controller to the adapter board.
NOTE:
If any Smart Array Controller other than the P410 is added after initial purchase (e.g. an upgrade),
an HP DL170e G6 SMART ARRAY CONTROLLER CABLE OPTION KIT (P/N 612207-B21) must be ordered to
connect the Smart Array Controller to the adapter board.
NOTE:
An external diskette drive, USB floppy drive key or virtual FDD using LO100 Advanced Pack is
needed to install storage controller drivers during a Windows operating system installation from a CD.
QuickSpecs
HP ProLiant DL2000 Multi Node Server
Standard Features
DA - 13847 North America — Version 31 — December 13, 2013
Page 4