HP ProLiant DL20 Gen10 Plus, Руководство по техническому обслуживанию и ремонту

Страница: 115 / 246

Removing and replacing the M.2 SATA SSD add-in card Removing and replacing the M.2 SATA SSD add-in card
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either a
riser slot blank or an expansion card installed.
CAUTION: CAUTION:
Before replacing a DIMM, expansion card, or other similar PCA components due to a perceived hardware error, make
sure first that the component is firmly seated in the slot. Do not bend or flex circuit boards when reseating components.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
Procedure Procedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Disconnect all SATA cables from the add-in card .
9. Remove the riser cage.
10. To remove the add-in card from the riser slot 1:
a. Remove the screw and slide the retainer bracket (callouts 1 and 2).
Retain the screw for future use.
b. Remove the add-in card from the slot 1 (callout 3).
11. To remove the add-in card from the riser slot 2:
a. Remove the screw (callout 1).
Retain the screw for future use.
b. Press and hold the release latch on the end of the slot 2 (callout 2).
Removing and replacing the M.2 SATA SSD add-in card 115