HP ProLiant DL145, Руководство пользователя

Страница: 77 / 105

Operating System Installation and Software
5-22 HP ProLiant DL145 Server User Guide
Setting Up the Network
Administrator and OEM level users can configure the network settings for the Management
Processor. To configure the settings:
1. Log in to the Management Processor CLI as described in “Logging In to the Management
Processor CLI” in this chapter.
2. At the ProLiant> prompt, enter
network setup
. The INET> prompt appears.
3. Enter any Management Processor network setup command. The available commands are
described in Table 5-9.
IMPORTANT: CLI commands are case-sensitive.
Table 5-9: Network Setup Commands
Command Description
state
Display the current setup information.
delay
Set the milliseconds to wait between pings.
host
Set the default active IP host.
length
Set the default ping packet length.
rtadd
Manually add an IP route to the table.
rtdel
Manually delete an IP route from the table.
routes
Display the IP route table.
setip
xxx.xxx.xxx.xxx
yyy.yyy.yyy.yyy
,
where
xxx.xxx.xxx.xxx is
the IP address and
yyy.yyy.yyy.yyy
is the subnet mask
Set the Management Processor IP address and
subnet mask.
setdgw
Set the Management Processor default gateway.
dhcp
Enable or Disable DHCP.
firewall
Display the current firewall settings.
setfirewall
Set the firewall parameters.
quit
Quit network setup.
help
Display menu help.
help general
Display menu help.
help diagnostics
Display diagnostic commands.
help telnet
Display Telnet commands.