QuickSpecs
HP ProLiant BL660c Gen9 Server Blade
Standard Features
c04543743 - DA - 15185 Worldwide - Version 5 - September 28, 2015
Page 3
35MB (1x35MB) L3 cache
NOTE:
E5-4660v3 processor
30MB (1x30MB) L3 cache
NOTE:
E5-4640v3, E5-4650v3, and E5-4655v3 processors
25MB (1x25MB) L3 cache
NOTE:
E5-4610v3 and E5-4620v3 processors
Chipset
Intel® C610 Series Chipset
Intel® E5-4600v3 Processor Family
NOTE:
For more information regarding Intel chipsets, please see the following:
http://www.intel.com/products/server/chipsets/
.
Upgradeability
Upgradeable to four (4) processors
On System
Management Chipset
HP iLO (Firmware HP iLO4 2.0), 4GB NAND with 1GB USB user space configurable via UEFI and accessible via
iLO. Read and learn more in the
iLO QuickSpecs.
NOTE:
For more information, visit:
http://www.hp.com/go/ilo
Memory Protection
Advanced ECC
Memory Online Spare Mode (Rank Spare Mode)
Memory
One of the following
depending on Model
Type
HP SmartMemory
DDR4 Load Reduced (LRDIMM), or Registered (RDIMM)
Standard (Pre-configured Models)
128GB (4 x 32GB) DDR4 2133MHz RDIMMs at 1.2V
128GB (8 x 16GB) DDR4 2133MHz RDIMMs at 1.2V
64GB (4 x 16GB) DDR4 2133MHz RDIMMs at 1.2V
Maximum (LRDIMM)
2TB (32 x 64GB) up to 2133MHz at 1.2V
Maximum (RDIMM)
1TB (32 x 32GB) up to 2133MHz at 1.2V
NOTE:
HP memory from previous generation servers (DDR3) is not compatible with this server. HP
SmartMemory is required to realize the memory performance improvements and enhanced functionality
listed in this document for Gen9. For additional information, please see the HP SmartMemory QuickSpecs
at:
http://www8.hp.com/h20195/v2/GetHTML.aspx?docname=c04111535
NOTE:
LRDIMM and RDIMM are distinct memory technologies and cannot be mixed within a server.
NOTE:
Depending on the memory configuration and processor model, the memory speed may run at
2133MHz, 1866MHz, or 1600MHz. Please see Memory Population Table or the Online Memory
Configuration Tool at:
http://h22195.www2.hp.com/MemoryTool/Home/Legal
Network Controller
One of the following
depending on Model
One (1) 20Gb 2-port FlexFabric FLB, 10Gb 2-port HP FlexFabric FLB, or 10Gb 2-port Ethernet FLB
NOTE:
Supports FCoE, , TCP/IP offload engine, hardware-based accelerated iSCSI, iSCSI boot, and
autosensing 10Gb/1Gb Ethernet.
NOTE:
Each port is autosensing the speed, and can interoperate with 1Gb HP BladeSystem c-Class
interconnect components. Both ports will operate at the same speed.
NOTE:
FlexFabric capabilities require the use of an HP Virtual Connect FlexFabric or Flex10/10D module
module.
Fibre Channel over Ethernet (FCoE) is supported with HP interconnects. Learn more at:
