Power supply
Description
Power supply, 180W, 92% efficient
Power supply, 180W, 85% efficient
WARNING!
To reduce potential safety issues, only the power supply provided with the computer, a
replacement power supply provided by HP, or a power supply purchased as an accessory from HP should be
used with the computer.
The power supply is located at the rear of the chassis. It is held in place by three Torx screws outside of the
chassis and a release lever inside of the chassis.
WARNING!
Voltage is always present on the system board when the computer is plugged into an active AC
outlet. To avoid possible personal injury and damage to the equipment the power cord should be
disconnected from the computer and/or the AC outlet before opening the computer.
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 20
).
2.
Remove the access panel (
3.
Remove the drive cage (
).
4.
From the outside, rear of the computer, remove the four Torx T15 screws that secure the power supply
to the rear of the chassis.
5.
From the inside of the chassis, disconnect all power cables from the PWR (1) and PWRCMD (2) system
board connectors.
6.
Press the release button at the front of the power supply (3).
Power supply
49
Содержание ProDesk 600 G3
Страница 1: ...Maintenance and Service Guide HP ProDesk 600 G3 Small Form Factor ...
Страница 4: ...iv About This Book ...
