HP ProCurve 6108, Руководство по управлению и настройке

Страница: 272 / 547

Port-Based Virtual LANs (VLANs) and GVRP
Port-Based Virtual LANs (Static VLANs)
want to make the VLAN permanent. After you convert a dynamic VLAN to
static, you must configure the switch’s per-port participation in the VLAN in
the same way that you would for any static VLAN.
Syntax
:
static-vlan <
vlan-id
> (
Use
show vlan
to list current VIDs .)
For example, suppose a dynamic VLAN with a VID of 125 exists on the switch.
The following command converts the VLAN to a static VLAN.
HPswitch(config)# static-vlan 125
Configuring Static VLAN Name and Per-Port Settings. The
vlan <
vlan-
id
> command, used with the options listed below, changes the name of an
existing static VLAN and changes the per-port VLAN membership settings.
N o t e
You can use these options from the configuration level by beginning the
command with
vlan <
vlan-id
>
, or from the context level of the specific VLAN.
Syntax
: name <
vlan-name
>
Changes the name of the existing static VLAN. (Avoid
spaces and the following characters in the
<
vlan-name
>
entry: 2 , # , $ , ^ , & , * , ( , and ) .)
[no] tagged <
port-list
>
Configures the indicated port(s) as Tagged for the specified
VLAN. The “
no
” version sets the port(s) to either
No
or (if
GVRP is enabled) to
Auto
.
[no] untagged <
port-list
>
Configures the indicated port(s) as
Untagged
for the
specified VLAN. The
“ no ”
version sets the port(s) to either
No
or (if GVRP is enabled) to
Auto
.
[no] forbid <
port-list
>
Configures the indicated port(s) as “forbidden” to
participate in the designated VLAN. The
“
no
” version sets
the port(s) to either
No
or (if GVRP is enabled) to
Auto .
auto <
port-list
>
Available if GVRP is enabled on the switch. Returns the
per-port settings for the specified VLAN to
Auto
operation.
Note that
Auto
is the default per-port setting for a static
VLAN if GVRP is running on the switch. (For information
on dynamic VLAN and GVRP operation, see
“GVRP” on page 12-33 .)
12-20