HP ProCurve 530, Руководство по установке и началу работы

Страница: 24 / 114

2-6
Installing the Access Point 530
Installation Procedures
In
stal
lin
g the
Access
P
oi
nt
530
2. Check the LEDs on the access point as described below.
When the access point is powered on, it performs its system initialization.
The system initialization takes between 30 seconds and one minute to
complete.
LED Behavior:
During the system initialization:
• The Power LED first turns on immediately, then the Power, LAN,
Radio 1, and Radio 2 LEDs turn on and off several times during phases
of the initialization.
When the system initialization completes successfully:
• The
Power
LED remains on green.
• The LAN and Radio LEDs on the top of the access point go into their
normal operational mode:
– If the RJ-45 network port and radio interfaces are connected to
active network devices, the LEDs should be blinking at a rate
proportional to the traffic rate. If there is no network activity, the
LEDs should still be blinking at approximately 5 second intervals.
– If the RJ-45 network port is not connected to an active network
device and the radio interfaces are disabled, the LEDs should be
off.
If the LED display is different than what is described above, the system
initialization has not completed correctly. Refer to chapter 5, “Trouble-
shooting” for diagnostic help.
Wireless LEDs Ethernet LED
Power LED