CAUTION:
Remove the screws in the order indicated by the callouts to ensure consistent
pressure over the processor board.
4.
Loosen the three Phillips PM2.5×5.0 captive screws
(5)
,
(6)
, and
(7)
that secure the fan/heat sink
assembly to the system board.
CAUTION:
Remove the screws in the order indicated by the callouts to ensure consistent
pressure over the processor board.
5.
Remove the fan/heat sink assembly
(8)
.
NOTE:
Due to the adhesive quality of the thermal material located between the fan/heat sink
assembly and system board components, it may be necessary to move the fan/heat sink assembly
from side to side to detach the assembly.
NOTE:
The thermal material must be thoroughly cleaned from the surfaces of the fan/heat sink
assembly and the system board each time the fan/heat sink assembly is removed. Thermal paste
is applied to the fan/heat sink assembly to correspond with components on the system board as
follows: the processor
(1)
and
(2)
, the Northbridge chip
(3)
and
(4)
, the graphics subsystem chip
(5)
and
(6)
, and three capacitors
(7)
and
(8)
. Replacement thermal material is included with all fan/
heat sink assembly, system board, and processor spare part kits.
Reverse this procedure to install the fan/heat sink assembly.
100 Chapter 4 Removal and replacement procedures
Содержание Pavilion DV6 Series
