1
1 Prepare Drive for Installation
Introduction
This chapter describes the tools, setup information and the steps necessary to
install a 68-pin SCSI hard disk drive into an HP Server. The drives documented in
this guide are listed in Table 1-1.
Table 1-1. Hard Disk Drive Product Numbers
HP Product Number
Capacity
RPM
P1167A 18.2
GB
10000
P4616A 18.2
GB
10000
P1169A 36.4
GB
10000
P3578A 73.4
GB
10000
These HP Ultra3 drives can operate in either Single-Ended (SE) mode as Ultra
drives with a maximum bus data rate of 40 MB/sec or in Low-Voltage Differential
(LVD) mode as Ultra3 drives with a maximum bus data rate of 160 MB/sec. The
terminator on the cable, other drives on the bus, and/or the host controller card,
determines whether the drive runs in SE or LVD mode.
NOTE
For any drive to run in LVD mode, all SCSI components on
that bus must be in LVD mode.
General Installation Steps
In general, the steps for installing a hard drive are shown below. Please refer to the
detailed instructions in each step before attempting to install your drive.
1. Prepare for Installation
2. Determine the Drive Type
3. Set the SCSI Address
5. Mount the Drive in the System
6. Connect the Drive Activity Light (if appropriate)
7. Connect the Drive
8. Configure the Drive
NOTE
Drives with the same product number can be of different types
and require different jumper settings. Match your drive with the
type shown in the figures before installation.
Содержание P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade
