Cabling
You must use the appropriate cables, and where applicable, surge protection, for your given
region. For compliance with EN55022 Class-B emissions requirements, use shielded Ethernet
cables. Cat 5e (or better) cabling is required.
Plenum installation
The AP can be installed in a plenum (UL2043 rating). The AP is suitable for use in environmental
air space in accordance with Section 300-22(C) of the National Electrical Code, and Sections
2-128, 12-010(3) and 12-100 of the Canadian Electrical Code, Part 1, CSA C22.1.
The AP should be installed in a similar orientation as in a ceiling installation. However, it is left to
a qualified installer to determine how to install and secure the AP in a plenum in an appropriate
and safe manner. Plenum-rated cables and attachment hardware must be used.
Country of use
CAUTION:
In some regions, you are prompted to select the country of use during setup. Once
the country has been set, the AP will automatically limit the available wireless channels, ensuring
compliant operation in the selected country. Entering the incorrect country may result in illegal
operation and may cause harmful interference to other systems.
Safety
Take note of the following safety information during installation.
•
If your network covers an area served by more than one power distribution system, be sure
all safety grounds are securely interconnected.
•
Network cables may occasionally be subject to hazardous transient voltages (caused by
lightning or disturbances in the electrical power grid).
•
Handle exposed metal components of the network with caution.
•
The AP is powered-on when connected to a PoE power source.
•
The AP and all interconnected equipment must be installed indoors within the same building
(except for outdoor antennas), including all PoE-powered network connections as described
by Environment A of the IEEE 802.3af standard.
Important information to read before installing
9
