Removal and Replacement Procedures
DIMM Installation Guidelines
The following guidelines must be followed when installing or replacing memory:
•
•
•
Always install memory in pairs of two identical DIMMs.
DIMMs installed in the server must be registered ECC DDR, 2.5 volts, 72 bits wide.
Install each pair of DIMMs into both slots within a single bank (1A with 2A; 3B with 4B;
5C with 6C). DIMMs must be installed in order, starting with bank A, B, and then C. Do
not skip over banks or skip DIMMs. The system will not function if not populated
properly.
Removing DIMMs
To remove a DIMM:
1. Power down and remove power from the server. Refer to “Powering Down the Server” in
this chapter.
2. Unlock and open the front bezel (tower server only).
IMPORTANT: You must unlock the tower bezel before removing the access panel. Refer to “Front
Bezel” in this chapter.
3. Remove the access panel. Refer to “Access Panel” in this chapter.
4. Remove the processor air baffle. Refer to “Processor Air Baffle” in this chapter.
5. Press both DIMM slot release latches outward (1).
6. Lift the DIMM module out of the slot (2).
Figure 2-49: Removing a DIMM
7. Repeat steps 5 and 6 to remove other DIMMs.
2-52
HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide
Содержание ML370 - ProLiant - G3
Страница 5: ...Contents Index HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide v ...
Страница 6: ......
