HP HPE ProLiant DL325, Руководство по техническому обслуживанию и ремонту

Страница: 88 / 165

CAUTION: To prevent mechanical damage or depositing oil on your hands or other contaminant to the heatsink
contact surface, hold the heatsink only by the edge of its base plate. Do not touch the heatsink fins.
CAUTION: To prevent thermal failure or component damage, do not move the heatsink once the bottom of its
base plate touches the top of the processor. Excessive heatsink movement can cause the thermal grease to
smear and become uneven. Voids in the compound can adversely impact the transfer of heat away from the
processor.
CAUTION: Heatsink screws must be tightened and loosened in alternating sequence. Do not overtighten the
screws as this might damage the system board or the processor socket.
a. Position the heatsink on top of the processor, ensuring that it is properly seated before securing the screws.
b. Use a T-20 Torx screwdriver to tighten the captive screws in the sequence specified on the heatsink label.
When using a torque wrench to tighten the screws, apply a torque of 1.58 N-m (14 lbf-in).
4. If removed, install the air baffle.
5. Install the access panel.
6. Install the server into the rack.
7. Power up the server.
8. If removed, install the front bezel.
Removing and replacing a processor
Removing a processor
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Removal and replacement procedures
88