Replacing or upgrading the hard drive
CAUTION:
To prevent information loss or an unresponsive system:
Shut down the computer before removing the hard drive from the hard drive bay. Do not remove the
hard drive while the computer is on, in the Sleep state, or in Hibernation.
If you are not sure whether the computer is off or in Hibernation, turn the computer on by pressing the
power button. Then shut down the computer through the operating system.
Removing the hard drive
NOTE:
Your computer may look slightly different from the illustration in this section.
To remove the hard drive:
1.
Save your work and shut down the computer.
2.
Disconnect AC power and external devices connected to the computer.
3.
Remove the battery (see
Inserting or removing the battery on page 32
).
4.
Remove the service door (see
Removing the service door on page 34
).
5.
Loosen the 3 hard drive screws
(1)
.
6.
Pull the plastic tab on the hard drive
(2)
towards the side of the computer to disengage the hard
drive from the connector.
7.
Use the plastic tab to lift the connector side of the hard drive up at an angle
(3)
and remove the
drive
(4)
from the computer.
Installing a hard drive
NOTE:
Your computer may look slightly different from the illustration in this section.
36
Chapter 5 Maintenance
Содержание EliteBook 8570p
Страница 1: ...Getting Started HP Notebook ...
Страница 4: ...iv Safety warning notice ...
Страница 8: ...viii ...
Страница 41: ...3 Remove the battery from the computer 2 Inserting or removing the battery 33 ...