HP E3472A, Руководство пользователя, Страница: 32 / 153

To test the HP E3472A/73A Emulator
If this is the first time you have used the HP E3472A/73A Emulator, you
should run the built-in performance verification test before you connect to a
target system.
For details on the procedure of the performance verification test, see page
108.
Installing the Emulation Memory Module
There are three types of emulation memory modules that can be inserted into
sockets on the probe.
N o t e
Installing the emulation memory requires the plastic rivet kit (HP Parts No.
64748-68700).
1
Remove plastic rivets that secure the plastic cover on the top of the
emulator probe, and remove the cover. The bottom cover is only
removed when you need to replace a defective active probe on the
exchange program.
2
Insert emulation memory module on the emulation probe. There is a
cutout on one side of the memory modules so that they can only be
installed one way.
To install memory modules, place the memory module into the socket groove
at an angle. Firmly press the memory module into the socket to make sure it
is completely seated. Once the memory module is seated in the connector
groove, pull the memory module forward so that the notches on the socket fit
Setting up the Emulator
To test the HP E3472A/73A Emulator
17