CLI commands
Config context
2-49
New
bandwidth control
Supported on: E-MSM720
bandwidth control
Enables bandwidth control for traffic going between the Access and the Internet network.
no bandwidth control
Disables bandwidth control for traffic going between the Access and the Internet network.
New
bandwidth control high
Supported on: E-MSM720
bandwidth control high
<min-tx-%>
<min-rx-%>
<max-tx-%>
<max-rx-%>
Sets the bandwidth rates (Tx minimum, Tx maximum, Rx minimum, and Rx maximum) for traffic
classed as High.
New
bandwidth control low
Supported on: E-MSM720
bandwidth control low
<min-tx-%>
<min-rx-%>
<max-tx-%>
<max-rx-%>
Sets the bandwidth rates (Tx minimum, Tx maximum, Rx minimum, and Rx maximum) for traffic
classed as Low.
New
bandwidth control max-rate
Supported on: E-MSM720
bandwidth control max-rate
<transmit>
)
<receive>
)
Sets the maximum transmit and receive rates in kbps.
These settings enable you to limit the total incoming or outgoing data rate on the Internet
network. If traffic exceeds the rate you set for short bursts, it is buffered. Long overages will
result in data being dropped. To utilize the full available bandwidth, the transmit and receive
limits should be set to match the incoming and outgoing data rates on the Internet network.
Parameters
<transmit>
Sets the maximum transmit rate in kbps.
<receive>
Sets the maximum receive rate in kbps.
About bandwidth control
Bandwidth rates for each level are defined by taking a percentage of the maximum transmit and
receive rates defined for the Internet network. Each bandwidth level has four rate settings:
Transmit rate - guaranteed minimum: This is the minimum amount of bandwidth that will be
assigned to a level as soon as outgoing traffic is present on the level.
Transmit rate - maximum: This is the maximum amount of outgoing bandwidth that can be
consumed by the level. Traffic in excess will be buffered for short bursts, and dropped for
sustained overages.
Receive rate - guaranteed minimum: This is the minimum amount of bandwidth that will be
assigned to a level as soon as incoming traffic is present on the level.
Содержание E-MSM720
