1 Preparing for Installation
This chapter shows you how to get started using the E-MSM466-R Access Point.
Package Contents
•
One E-MSM466-R
•
One weatherproof RJ-45 Ethernet connector
•
One pole mount/wall mount bracket
•
Bracket bolts (x2), lock washers (x2), flat washers (x4)
•
Wall anchors (x4) and screws (x4)
•
Pole clamps (x2) for a 5 cm (2 inch) diameter pole
•
Documentation
Identifying E-MSM466-R components
E-MSM466-R key components are identified as follows:
Figure 1 E-MSM466-R key components
1
2
6
5
3
4
1
1
4. Ethernet connector
1. Radio 2 antenna connectors (x3)
5. Reset button
2. Vent Nut (do not remove)
6. Status LEDs (Power, Ethernet, Radio 1, Radio 2)
3. Grounding lug with screw
NOTE:
Three Radio 1 antenna connectors are available on the opposite end of the E-MSM466-R.
Protection Equipment Needed
In addition to the items supplied with the E-MSM466-R, protection equipment will be required
according to your electrical code. Consult the respective Antenna Guide (available online, search
by antenna part number), including the Lightning Arrester section for important safety information
and instructions. Note that although the E-MSM466-R includes a built-in Ethernet surge suppressor,
you should add an Ethernet surge suppressor where the Ethernet cable enters the building.
Package Contents
5
