HP D6030A - NetServer - E50, Руководство по установке

Страница: 35 / 106

29
5 Installing Additional Memory
Introduction
This chapter provides the instructions for installing and removing DIMMs on the
system board in the HP NetServer E 200. The video memory is provided on the
AGP adapter board and comes with 4 MB standard and cannot be upgraded.
NOTE
The EDO DIMMs and PC 100 SDRAM DIMMs from earlier
HP NetServer models will fit into the DIMM slots in the HP
NetServer E 200, but the EDO DIMMs and PC 100 SDRAM
will not function properly. Use only 133 MHz SDRAM
registered DIMMs acquired from HP.
To ensure you have the correct DIMMs before installation, refer to one of the
following for a list of qualified DIMMs:
•
HP Order Assistant on the HP web site at:
http://www.hp.com/go/netserver
•
HP Customer Service
Tools Required
Use an anti-static service kit (3M 8501/8502/8503 or equivalent). This kit includes
a static-dissipating work surface, a chassis clip lead, and a wrist-strap.
Memory Installation Guidelines
•
The HP NetServer E 200 uses only 3.3V, 133 MHz (PC133), registered
SDRAM DIMMs, which are electrically different from the EDO and
PC100 SDRAM memory modules used in previous HP NetServer models.
NOTE The registered DIMMs are required because the HP NetServer
uses error checking.
•
The HP NetServer ships with at least one DIMM (64 MB) in the three
DIMM slots of main memory on the system board and supports up to 728
MB. See Figure 5-1 for slot location.