HP Compaq L2301w, Руководство пользователя

Страница: 20 / 39

Using the Auto-Adjustment Function
You can optimize the screen performance for the VGA (analog) input by using the Auto/Select button
on the monitor and the auto-adjustment pattern software utility on the CD provided.
Do not use this procedure if the monitor is using a DVI input. If the monitor is using a VGA (analog)
input, this procedure can correct the following image quality conditions:
● Fuzzy or unclear focus
●
Ghosting, streaking or shadowing effects
●
Faint vertical bars
●
Thin, horizontal scrolling lines
●
An off-center picture
CAUTION: Burn-in image damage may occur on monitors that display the same static image on
screen for a prolonged period of time (12 consecutive hours of non-use). To avoid burn-in image damage
on your monitor screen, you should always activate a screen saver application or turn off the monitor
when it is not in use for a prolonged period of time. Image retention is a condition that may occur on all
LCD screens. Monitors with a “burned-in image” are not covered under the HP warranty.
To use the auto-adjustment feature:
1. Allow the monitor to warm up for 20 minutes before adjusting.
2. Press the Auto/Select button on the monitor front panel.
● You can also press the Menu button, then select Image Control > Auto-Adjustment from
the OSD Main Menu. Refer to Adjusting the Monitor Settings on page 16 in this chapter.
●
If the result is not satisfactory, continue with the procedure.
3. Insert the CD in the disc drive. The CD menu is displayed.
4. Select Open Auto-Adjustment Software . The setup test pattern is displayed.
5. Press the Auto/Select button on the monitor front panel to produce a stable, centered image.
6. Press the ESC key or any other key on the keyboard to exit the test pattern.
14 Chapter 4 Operating the Monitor ENWW