v
B321/B421
Information for U.K. only
WARNING – THIS APPLIANCE MUST BE EARTHED.
Important:
(A)
(B)
This apparatus is supplied with an approved moulded 13A plug.
To change a fuse in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fit new fuse which should be a BS 1362 5A,A.S.T.A. or BSI
approved type.
3.
Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should
be cut off and an appropriate 3-pin plug fitted in its place.
If the mains plug contains a fuse, this should have a value of
5A. If a plug without a fuse is used, the fuse at the distribution
board should not be greater than 5A.
NOTE
: The severed plug must be destroyed to avoid a
possible shock hazard should it be inserted into a 13A
socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured in accordance with the
following code:
BLUE – “NEUTRAL” (“
N
”)
BROWN – “LIVE” (“
L
”)
GREEN & YELLOW – “EARTH” (“
E
”)
1. The GREEN & YELLOW wire must be connected to the
terminal in the plug which is marked with the letter “
E
” or
by the Earth symbol or coloured GREEN or GREEN &
YELLOW.
2. The BLUE wire must be connected to the terminal which is
marked with the letter “
N
” or coloured BLACK.
3. The BROWN wire must be connected to the terminal which
marked with the letter “
L
” or coloured RED.
Before replacing the plug cover, make certain that the cord grip
is clamped over the sheath of the lead – not simply over the
three wires.
