HP Apollo 2000 System, Руководство по техническому обслуживанию и ремонту

Страница: 36 / 178

Remove the chassis from the rack
About this task
WARNING:
The chassis is very heavy. To reduce the risk of personal injury or damage to the equipment:
• Observe local occupational health and safety requirements and guidelines for manual material
handling.
• Remove all installed components from the chassis before installing or moving the chassis.
• Use caution and get help to lift and stabilize the chassis during installation or removal, especially
when the chassis is not fastened to the rack.
WARNING:
To reduce the risk of personal injury or damage to the equipment, you must adequately support the
chassis during installation and removal.
WARNING:
Always use at least two people to lift the chassis into the rack. If the chassis is being loaded into the
rack above chest level, a third person must assist with aligning the chassis with the rails while the other
two people support the weight of the chassis.
CAUTION:
Before installing the chassis into the rack or removing the chassis from the rack, Hewlett Packard
Enterprise recommends removing the nodes, the drives, and the power supplies. Because a fully
populated chassis is heavy, removing these components facilitates moving the chassis.
Procedure
1. Power down all nodes .
2. Disconnect all peripheral cables from the nodes and chassis.
IMPORTANT:
Label the drives before removing them. The drives must be returned to their original locations.
3. Remove all nodes from the chassis .
36 Remove the chassis from the rack