HP AdvanceStack 208, Руководство по установке оборудования

Страница: 45 / 112

4-9
Configuring the Switch From the Console
Configurable Features
C
onf
igur
ing the S
w
itch F
ro
m
the C
ons
ole
To manually configure the switch for IP:
1. From the Configuration screen, select
Internet (IP) Service
to
display the above screen.
2. Press [E] (for Edit ).
3. Select the
IP Config
field and use the Space bar to select
Manual
.
4. Select the
IP Address
field and enter the IP address you want to assign
to the switch.
5. Select the
Subnet Mask
field and enter the subnet mask for the IP
address.
6. If you want to reach off-subnet destinations, select the
Gateway
field
and enter the IP address of the gateway router.
7. Press [Enter] , then [S] (for
Save
).
8. Return to the Main Menu and reboot the switch.
Using Bootp
In its default configuration, the switch is configured to enable Bootp opera-
tion. However, if an IP address has previously been configured or if the
IP
Config
parameter has been set to
Disabled
, then you will need to use this
procedure to reconfigure the parameter to enable Bootp operation.
This procedure assumes that a Bootp database record has already been
entered into an appropriate Bootp server, and that the necessary network
connections are in place. For samples of Bootp server table entries, see “Bootp
Database Entries” later in this chapter.
To configure the switch for Bootp:
1. In the Main Menu, select
Configuration
.
2. In the Configuration screen select
Internet (IP) Service
.
3. Press [E] (for Edit mode), then use
[v]
to move the cursor to the
IP Config
parameter field.
4. Use the Space bar to select the
Use Bootp
option for the
IP Config
parameter. (This disables access to the IP Address, Subnet Mask, and
Gateway parameters.)
5. Press
[Enter]
to exit from edit mode, then press
[S]
to save the configuration
change.
YUMAMOD.BK : 4_ymcnfg.fm5 Page 9 Thursday, February 20, 1997 12:54 PM