HP AdvanceStack 100VG, Инструкция по установке и справочник

Страница: 7 / 32

HP AdvanceStack 100VG Hub-7E
At A Glance
The HP J3137A AdvanceStack 100VG Hub-7E is a high-speed multiport
repeater. With this hub, you can connect computers and other devices to-
gether in an unshielded twisted-pair cable network. This hub can be used to
upgrade your 10 Mbit/s Ethernet/IEEE 802.3 network that uses unshielded
twisted-pair cables to a 100 Mbit/s network.
Throughout this manual, this hub will be called the Hub-7E. The following
illustration shows the Hub-7E.
Features
Network Connections Six RJ-45 (twisted-pair) ports to connect to end nodes or other devices.
An Uplink port to cascade to another 100VG hub such as the following hubs:
HP J2413A AdvanceStack 100VG Hub-7M
HP J2410A AdvanceStack 100VG Hub-15
HP J2415A AdvanceStack 100VG Hub-14
Ethernet and Token Ring Support Support for both Ethernet and Token Ring framing. If you have 100VG LAN
adapters with 100VG Token Ring drivers, you can select the Token Ring position.
Remote Management An RS-232 port to connect an ASCII console for monitoring and troubleshooting
the hub and network.
Modular, Easy-to-Use Design LEDs showing power, activity, cascade, fault, and port status provide quick,
easy-to-read hub status information and troubleshooting assistance.
A small footprint that allows you to install the hub in a variety of ways, including
on a desk, under a desk, or on a wall.
Standards-Based Compatibility Compatible with the IEEE 802.12 standard.
Frame switch
Hub status LEDs
Twisted-pair
ports
twisted-pair port LEDs
Uplink port for
hub to hub
connections
At A Glance
1