Remove the MSA from the rack
1.
Remove the decorative bezel from the front of the MSA by grasping
the outside edges and pulling with suf
fi
cient force to disengage
the retaining clips.
15642
2.
Loosen the thumbscrews securing the MSA to the front of the rack,
and then slide the MSA out of and away from the rack.
Installing the replacement chassis
Record the serial numbers of the two chassis
IMPORTANT:
Depending on the MSA model and
fi
rmware version, the serial
number of the original chassis may automatically be transferred
to the replacement chassis. For continued service and support
from HP authorized service personnel, the serial number of the
original chassis must also be physically recorded on the label of
the replacement chassis.
The product label is located on the side of the MSA chassis.
15641
Install the MSA in the rack
1.
Slide the MSA into the rack, and then secure the MSA to the front
of the rack, using the thumbscrews on the front of the MSA.
2.
Attach the decorative bezel on the front of the MSA by aligning
the pins and retaining clips on the back of bezel with the
corresponding locations on the front of the chassis. Then, with even
pressure, push
fi
rmly on the bezel until the retaining clips engage.
15649
Install the controllers
1.
Press the controller thumb latch and rotate the latch handle out.
1
2
15493
2.
Slide the controller into the chassis and then push
fi
rmly to ensure
a good seat.
3.
Rotate the latch handle inward, pressing until it is
fl
ush against
the front panel.
4.
Install the other controller or blank.
Install the power supply modules
1.
Slide the module into the chassis power supply slot until the latch
clicks into place.
15646
2.
Install the other module.
Page 3
