HP A5500 EI Switch Series, Руководство по настройке

Страница: 342 / 443

330
Figure 87 Assert mechanism
As shown in Figure 87 , after Router A and Router B receive an (S, G) IPv6 multicast packet from the
upstream node, they both forward the packet to the local subnet. As a result, the downstream node
Router C receives two identical multicast packets, and both Router A and Router B, on their own local
interface, receive a duplicate IPv6 multicast packet that the other has forwarded. Upon detecting this
condition, both routers send an assert message to all IPv6 PIM routers on the local subnet through the
interface that received the packet. The assert message contains the following information: the multicast
source address (S), the multicast group address (G), and the preference and metric of the IPv6 unicast
route to the source. By comparing these parameters, either Router A or Router B becomes the unique
forwarder of the subsequent (S, G) IPv6 multicast packets on the multi-access subnet. The comparison
process is as follows:
1.
The router with a higher IPv6 unicast route preference to the source wins.
2.
If both routers have the same IPv6 unicast route preference to the source, the router with a smaller
metric to the source wins.
3.
If a tie in the route metric to the source exists, the router with a higher IPv6 link-local address wins.
IPv6 PIM-SM overview
IPv6 PIM-DM uses the flood-and-prune principle to build SPTs for IPv6 multicast data distribution.
Although an SPT has the shortest path, it is built with a low efficiency. Therefore the PIM-DM mode is not
suitable for large-sized and medium-sized networks.
IPv6 PIM-SM is a type of sparse-mode IPv6 multicast protocol. It uses the pull mode for IPv6 multicast
forwarding and is suitable for large-sized and medium-sized networks with sparsely and widely
distributed IPv6 multicast group members.
The basic implementation of IPv6 PIM-SM is as follows:
•
IPv6 PIM-SM assumes that no hosts need to receive IPv6 multicast data. In the IPv6 PIM-SM mode,
routers must specifically request a particular IPv6 multicast stream before the data is forwarded to
them. The core task for IPv6 PIM-SM to implement IPv6 multicast forwarding will build and maintain
rendezvous point trees (RPTs). An RPT is rooted at a router in the IPv6 PIM domain as the common
node, or rendezvous point (RP), through which the IPv6 multicast data travels along the RPT and
reaches the receivers.
•
When a receiver is interested in the IPv6 multicast data addressed to a specific IPv6 multicast
group, the router connected to this receiver sends a join message to the RP that corresponds to that