Re-load the Correction Constants
1.
2.
3.
4.
Insert the “EEPROM Backup Disk” (created earlier) into the disk drive.
Press
Use the front panel knob to highlight the
file
where N12345 represents the file name of the EEPROM data for the analyzer.
Press
RECALL
to down load the correction constants data into the
instrument
Press
to load the EEPROM Constants. Verify that good data was transferred to
EEPROM by performing a simple measurement.
Re-load the Instrument States
If you want to re-load the analyzer’s instrument states from your backup disk (created earlier),
refer to “Printing, Plotting, and Saving Measurement Results,” located in the User’s Guide. This
procedure may be very time consuming, depending on the number of instrument states that
you choose to re-load. Each instrument state file will have to be renamed.
Configure the Analyzer to Produce a Time Stamp
You
can set a clock, and then activate it, if you want the time and date to appear on your
hardcopies.
Press (System) SET CLOCK
Press
Press
Press
Press
Press
SET YEAR and enter the current year (four digits), followed by
SET
and enter the current month of the year, followed (xl.
SET DAY and enter the current day of the month, followed by
SET HOUR
and enter the current hour of the day (O-23), followed by
SET MINUTES
and enter the next immediate minute, followed by
Press ROUND SECONDS when the current time is exactly as you have set it.
Press TIME STAMP until TIME STAMP’ ON appears on the
label.
14
Installation Note
