Emulator Pod
Configuration
To access the emulator pod configuration questions, you must answer
"yes" to the following question.
Modify emulator pod configuration?
Target memory
access size?
This question allows you to specify the types of cycles that the
emulation monitor use when accessing target system memory. When
an emulation command requests the monitor to read or write target
system memory locations, the monitor will either use byte or word
instructions to accomplish the read/write.
byte
Specifies that the emulator will access target system
memory by byte accesses.
word
Specifies that the emulator will access target system
memory by word accesses.
Respond to target
system interrupts?
This configuration allows you to specify whether or not the emulator
responds to interrupt signals from the target system during foreground
operation.
yes
The emulator will respond to interrupt signals from
the target system.
no
The emulator will not respond to interrupt signals
from the target system.
Note
You may need to set up switches inside the emulation pod to accept
interrupts from the target system. Refer to the manual provided with
your emulation pod.
4-16 Configuring the Emulator
Содержание 64147A
