HP 5363B, Руководство по эксплуатации и обслуживанию

Страница: 13 / 157

M o d e l 53638
I n sta l l a t i o n
2 - 1. I NT R O D U CT I O N
SECTION II
INSTALLATION
2-2 . T h i s sec t i o n p rovi des i nf o r m a t i o n f o r u n pa c k in g , i n s pect i o n , p repa ra t i o n for u s e ,
storag e , a n d s h i p me n t of the 5363 8 .
2 -3. U NP A C K I N G A N D I N SP E CT I O N
2-4 . If the s h i p p i n g ca rton i s d a m aged , i n s pect t h e 53638 f o r v i s i b l e d a m a g e sc ratc h e s ,
d e nts, e t c . . If the i nstru m e n t i s d a ma g e d , n o t i f y the c a r rie r a n d t h e nea re st Hewlett-Packa rd
Sales a n d S u p port Offi c e i m m e d iate l y off i c e s a re l i sted at t h e b a c k of this m a n ua l . Kee p t h e
s h i p p i ng c a rt o n a n d pac k i n g mate r i a l for t h e c a r rie r's i n specti o n . The H P S a l e s a n d S u p port
Offi c e w i l l a rra n g e f o r re pa i r o r re p l a c e m e n t of yo u r i nstru m e n t w i t h o u t waiting for t h e c laim
a g a i n s t the c a r r i e r to be settled .
T h e p r o b e s c a n b e dama g e d by a n e le ctrostatic d i s c h a rg e t h r o u g h
t h e p ro b e ti p . Keep the p ro b e ti p s h i e l d attac h ed o ve r the p r o be ti p s
w h e n they a r e n o t i n u s e .
2 -5. P R EPARAT I O N F O R U S E
Before connecting this instrument to an ac power line, be sure that
the line voltage selector switch on the rear panel is set to proper
position as shown in Figure
3-2.
2-6 . Powe r Require ments a n d Line Voltage
2 - 7 . T h i s i n s t r u m e n t o p e rates o n s i n g l e p h a se 1 OOV , 1 20 V , 2 2 0 V , o r 240V ac +5% - 1 0% volts
at 48-440 Hz. M a x i m u m power req u i re m e n t i s 30 VA .
Figure 3 -2
shows t h e l i ne selecto rs a n d
f u s e h o l d e r. To avo i d i n st r u m e n t d a ma g e , the l i ne selectors m ust b e s e t t o t h e c o r rect
pos i t i o n s a n d the c o r rect fuse ' a s l a be l e d o n t h e rea r p a n e l m ust be i nsta l l e d . W h e n s h i p ped ,
the s e l ec tors a re set f o r 1 20 -v o l t o p e rati o n .
2-8. Power Cables
WARNING
TO P ROTECT OPERATING AND SERVICING PERSONNEL, THIS
INSTRUMENT IS EQUIPPED W I TH A THREE-PIN POWER RE­
CEPTACLE. THE CENTER P IN OF THE RECEPTACLE CON­
NECTS THE INSTRUMENT CHASS IS AND PANELS
TO
EARTH
GROUND WHEN USED WITH A PROPERLY W IRED THREE­
CONDUCTOR OUTLET AND POWER CABLE. I MPROPERLY
GROUNDED EQUIPMENT CAN RESULT I N HAZARDOUS
POTENTIALS
BETWEEN EQUIPMENT.
2- 1