2.
To verify that the host has been created, issue the
showhost
command.
# showhost
Id Name Persona -WWN/iSCSI_Name- Port
...
2 hpux-host HPUX-legacy 1122334455667788 ---
1122334455667799 ---
Configuring the HP 3PAR Storage System Running InForm OS 2.2.x
This section describes how to configure the HP 3PAR Storage System running InForm OS 2.2.x.
REQUIRED
The following setup must be completed before connecting the HP 3PAR Storage System port to a
device.
Configuring Ports for a Direct Connection
To configure the HP 3PAR Storage System ports for a direct connection, complete the following
steps.
1.
Set each HP 3PAR Storage System port to port personality 5 by issuing
controlport
persona 5 <X:X:X>
, where
<X:X:X>
is the port location, expressed as node:slot:port.
# controlport persona 5 1:2:1
2.
Verify that each port has the appropriate personality defined:
# showport -par
N:S:P ConnType CfgRate MaxRate Class2 VCN ------------Persona-------------
IntCoal
...
1:2:1 loop auto 2Gbps disable disabled (5) aglt, g_hba, hp, 0, DC
enabled
...
NOTE:
When deploying your storage server in a direct connection, the HP Tachyon HBA
WWN does not show up.
Configuring Ports for a Fabric Connection
To configure the HP 3PAR Storage System ports for a fabric connection, complete the following
steps.
1.
Set each storage server port that will connect to a fabric to port persona 8 by issuing
controlport persona 8 <X:X:X>
, where
<X:X:X>
is the port location, expressed as
node:slot:port.
8
Configuring the HP 3PAR Storage System for Fibre Channel
