HP 3C905C-TX, Руководство по установке

Страница: 21 / 30

English 21
HP 10/100 3Com 3C905C-TX Network Interface Card Installation Guide
HP Support Services
The PC Cannot Be Started or Woken-Up from the Network
1 Refer to “Remote Wake-Up and Remote Power-On Support” on
page 4 to check that your combination of power management
solution and operating system is supported.
2 If the PC has been powered off (for example, due to an electrical
power failure, or because the power cord has been removed), the
Remote Power On (RPO) will not work. To enable the RPO, you
must first power on the PC, allow the Operating System to boot,
then shut down the PC.
3 Check that the WOL connector cable is connected to the network
interface card and to the PC’s system board.
4 Check that the LAN-specific fields in the HP PC Setup utility are
correctly set (refer to “Updating LAN-specific Fields in the HP
PC Setup Utility” on page 10.)
HP Support Services
The latest drivers and utilities are available on HP’s Web site
at:
For HP Vectra PCs
www.hp.com/go/vectrasupport
For HP Brio PCs
www.hp.com/go/briosupport
For HP Kayak PC
Workstations
www.hp.com/go/kayaksupport
3Com.book Page 21 Tuesday, August 31, 1999 11:36 AM