HP 330834-B21 - StorageWorks Ultrium 460 Tape Library Drive Module, Техническое справочное руководство

Страница: 14 / 44

14 HP-UX Systems
target 1 8/16/5.5 tgt CLAIMED DEVICE
disk 0 8/16/5.5.0 sdisk CLAIMED DEVICE SEAGATE ST34573N
target 2 8/16/5.7 tgt CLAIMED DEVICE
ctl 2 8/16/5.7.0 sctl CLAIMED DEVICE Initiator
processor 0 62 processor CLAIMED PROCESSOR Processor
memory 0 63 memory CLAIMED MEMORY Memory
After you have installed the new tape drive, you can check that it has been
attached successfully. From a shell window (
hpterm/xterm
), execute
ioscan
to display the list of attached devices.
For an HP Ultrium drive, execute the following:
% /sbin/ioscan -f | grep "Ultrium"
The new lines should look similar to the following, where the
4
in the
I
field
represents the instance of the SCSI tape driver, not the SCSI ID:
tape 4 2/0/1.5.0 stape CLAIMED DEVICE HP Ultrium
Note If you are installing the drive onto a Storage Area Network
(SAN), the fibre channel/SCSI bridge will also appear in the
list of attached devices.
If you cannot find the Ultrium drive , this may be because the kernel does not
contain the correct driver. U se the System Administration Manager (
sam
) to
add
stape
to the kernel:
To add
stape
to the kernel using
sam
:
1
% sam
2
Select the following:
Kernel Configuration
Drivers
3 Highlight the
stape
driver. If the driver has not been added to the kernel,
both Current State and Pending State will read “Out”.
4 Select the following:
Actions
Add Driver to Kernel
The Pending State will now read “In”.
5
To add the new driver to the kernel, select: