HP 3300A, Техническое руководство

Страница: 54 / 62

TM 11-6625-2495-14&P
APPENDIX D
MAINTENANCE ALLOCATION
SECTION I. INTRODUCTION
D-1. General
This appendix provides a summary of the maintenance
operations for SG-747/U. It authorizes categories of
maintenance for specific maintenance functions on
repairable items and components an the tools and
equipment required to perform each function. This
appendix may be used as an aid in planning
maintenance operations.
D-2. Maintenance Function.
Maintenance functions will be limited to and define as
follows:
a. Inspect. To determine the serviceability of a
item by comparing its physical, mechanical, and/or
electrical characteristics with established standard
through examination.
b. Test. To verify serviceability and to detect
incipient failure by measuring the mechanical or
electrical characteristics of an item and comparing those
characteristics with prescribed standards.
c. Service. Operations required periodically to
keep an item in proper operating condition, i.e., to clean
(decontaminate), to preserve, to drain, to paint, or to
replenish fuel, lubricants, hydraulic fluids, or compressed
air supplies.
d. Adjust
. To maintain, within prescribed limits by
bringing into proper or exact position, or by setting the
operating characteristics to the specified parameters.
e. Align. To adjust specified variable elements of
an item to bring about optimum or desired performance.
f. Calibrate . To determine and cause correction to
be made or to be adjusted on instruments or test
measuring and diagnostic equipments used in precision
measurement. Consists of comparisons of two
instruments, one of which is a certified standard of
known accuracy, to detect and adjust any discrepancy in
the accuracy of the instrument being compared.
g. Install . The act of emplacing, seating, or fixing
into position an item, part, module (component or
assembly) in a manner to allow the proper functioning of
the equipment or system.
h. Replace. The act of substituting a serviceable
like type part, subassembly, or module (component or
assembly) for an unserviceable counterpart.
i. Repair.
The application of maintenance services
(inspect, test, service, adjust, align, calibrate, replace) or
other maintenance actions (welding, grinding, riveting,
straightening, facing, remachining, or resurfacing) to
restore serviceability to an item by correcting specific
damage, fault, malfunction, or failure in a part,
subassembly, module (component or assembly), end
item, or system.
j. Overhaul.
That maintenance effort
(service/action) necessary to restore an item to a
completely serviceable/operational condition as
prescribed by maintenance standards (i.e., DMWR) in
appropriate technical publications. Overhaul is normally
the highest degree of maintenance performed by the
Army. Overhaul does not normally return an item to like
new condition.
k. Rebuild.
Consists of those services/actions
necessary for the restoration of unserviceable equipment
to a like new condition in accordance with original
manufacturing standards. Rebuild is the highest degree
of materiel maintenance applied to Army equipment.
The rebuild operation Includes the act of returning to
zero those age measurements (hours, miles, etc.)
considered in classifying Army equipments/components.
D-3. Column Entries.
a. Column 1, Group Number. Column 1 lists group
numbers, the purpose of which is to identify components,
assemblies, subassemblies, and modules with the next
higher assembly.
b. Column 2, Component/Assembly. Column 2
contains the noun names of components, assemblies,
subassemblies, and modules for which maintenance is
authorized.
c. Column 3, Maintenance Functions. Column 3
lists the functions to be performed on the item listed in
column 2. When items are listed without maintenance
functions, it is solely for purpose of having the group
numbers in the MAC and RPSTL coincide.
d. Column 4, Maintenance Category. Column 4
D-1