LED board
Description
Spare part number
LED board (includes cable and Mylar cover)
481090-001
Before removing the LED board, follow these steps:
1.
Shut down the computer.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 30
).
5.
Remove the following components:
a.
Flash drive (see
Flash drive on page 36
)
b.
Optical drive (see
Optical drive on page 38
)
c.
Switch cover and keyboard (see
Switch cover and keyboard on page 40
)
d.
Display assembly (see
Display assembly on page 47
)
e.
Bluetooth module compartment cover (see
Top cover on page 52
)
f.
Top cover (see
Top cover on page 52
)
Remove the LED board:
1.
Release the ZIF connector
(1)
to which the LED board cable is attached and disconnect the LED
board cable
(2)
from the system board.
2.
Remove the LED board
(3)
from the clip in the base enclosure.
NOTE:
The LED board cable is included with the LED board and is also available in the Cables Kit,
spare part number 481092-001.
Component replacement procedures
55
Содержание 2533t - Compaq Mobile Thin Client
