HP LIGHT SYSTEM 66343, Инструкция по эксплуатации

Страница: 12 / 17

12
Special safety instructions
Not suitable for use as permanent lighting
installation.
Maintain a safety gap of at least 1 metre from the
light to the object to be illuminated.
Place on a level, flat surface. Do not place on
surfaces with an incline of more than 6 degrees.
Do not touch the protective glass or grill when
the light is on or hot.
Use
Place the light in a stable position where required.
Slacken the adjustment screw (4), and adjust light
housing to required angle. Tighten adjustment
screw. Do not over-tighten. Connect to mains
electricity and switch on at socket.
ENGLISH
INSTRUCTION MANUAL
Fitting halogen bulb
Check light is disconnected from mains, and is
cold to the touch. Remove upper screw (6) and
open protective grille (2) and protective glass (3).
Fit bulb (7) into socket without touching it with
bare fingers. Close the glass again, checking that
the rubber seal is correctly in place. Replace the
upper screw.
Environmental information
You can help protect the environment!
Follow local environmental regulations:
Dispose of unwanted electrical
equipment at an approved refuse
disposal centre.